sherif Posted July 3 Share Posted July 3 The plans for cozy shows a piece of foam 42" x 28.8" to be glassed with 2 plys, the orientation angle is not explicitly mentioned but if I assumed 45 degrees the part will not fit the 38" wide roll. In order to fit the angle has to be a lot shallower on both plys, is that the intention? Quote Link to comment Share on other sites More sharing options...
sherif Posted July 3 Author Share Posted July 3 actually calculated the angle, should be around 33 degrees, probably ok Quote Link to comment Share on other sites More sharing options...
Jon Matcho Posted July 3 Share Posted July 3 It is meant to be 45 degrees. You'll just need to use more UNI for these situations. Check Chapter 3 for whether the plies should be overlapped or butted. Quote Jon Matcho Builder & Canard Zone Admin Now: Rebuilding Quickie Tri-Q200 N479E Next: Resume building a Cozy Mark IV Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.